Sanus Wall Mount

If you just purchased a large, flat panel television, a Sanus LT25 is a compatible tilting wall mount. The Sanus LT25 holds flat panel televisions from 32-inches to 70-inches in size. It holds up to 175 lbs. of weight, tilts horizontally and has space for your television components in between the mount. The mount is 30 inches by 18.25 inches by 3-inches and weighs 12 lbs.. Its light weight makes it easy to install.

Instructions

Bracket Installation

1

Place your TV on a padded surface with the screen facing down. Locate the bracket holes in the back of the TV.

2

Determine the diameter of bracket screws to use. The installation kit comes with different diameter spacers, shoulder brackets, washers and screws.

3

Place the spacers in the bracket holes on the back of your TV. Place the bracket over the spacer on the back of the TV. Place a shoulder bracket and washer over the screw and screw the spacer, bracket, shoulder bracket, washer and screw in place using a Philips screwdriver.

Wood Stud Wall

4

Place a stud finder flat against the wall where you want to install the mount. The stud finder will find the wooden planks to support the weight of the mount and TV.

5

Mark the planks with a pencil by drawing a vertical line where the planks are located.

6

Place the mount horizontally against the wall. Line the mounting holes of the mount to the marks for the studs. Place a level on top of the mount to ensure it is level. Insert a pencil into each mounting hole to mark them. Remove the mount from the wall.

7

Drill a 2.5-inch pilot hole into each of the marks. Use a 3/16-inch drill bit and a power drill. Insert the plastic anchors (Item 26) into each pilot hole. Place the mount onto the wall. Insert the 5/16-inch screws (Item 25) into washers (Item 24).

8

Tighten the screws and washers into the pilot holes using an adjustable wrench. The mount is secured to the wall.

Concrete Wall

9

Place the mount horizontally against the wall. Place a level on top of the mount to ensure it is level. Mark six spots in the mounting holes using a pencil. Do not mark onto mortar areas. They are not strong enough to hold the mount. Remove the mount from the wall.

10

Drill a 2.5-inch pilot hole into each of the marks. Use a 3/16-inch drill bit and a power drill. Insert the plastic anchors (Item 26) into each pilot hole. Place the mount onto the wall. Insert the 5/16-inch screws (Item 25) into washers (Item 24).

11

Tighten the screws and washers into the pilot holes using an adjustable wrench. The mount is secured to the wall.

TV Mounting

12

Lift the TV with the brackets facing the wall mount.

13

Angle the TV and place the top hooks of the bracket above the top ridge of the wall mount.

14

Lower the bottom TV into place. The top hooks are secured to the top ridge of the wall mount. Your Sanus LT25 is now installed to your TV and the wall.